SGM

Durazzo SDS

Safety Data Sheet for SGM Durazzo, revised 2016-05-23.

Open the full SDS (PDF)

Hazards

• Causes skin irritation.
• Causes serious eye damage.
• May cause an allergic skin reaction.
• May cause cancer.
• May cause respiratory irritation.
• May cause damage to organs (Lung) through prolonged or repeated exposure.

Protective equipment

• In situations where there is potential splash or puff exposure of cement products, wear unvented goggles or a face shield. In extremely dusty or unpredictable environments wear unvented or indirectly
• Wear appropriate chemical resistant gloves.
• Where prolonged exposure to unhardened Portland cement products might occur, wear impervious clothing and gloves to prevent skin contact. Wear sturdy boots that are impervious to water and eliminate f
• Use NIOSH/MSHA approved (30 CFR 11) or NIOSH approved (42 CFR 84) respirators in poorly ventilated areas, or if an applicable exposure limit is exceeded, or when dust causes discomfort or irritation.
• Wear appropriate thermal protective clothing, when necessary.

First aid

• Eyes: Do not rub eyes. Immediately flush eyes with plenty of water for at least 15 minutes. Remove any contact lenses and open eyelids wide apart. Continue rinsing. Get medical attention immediately.
• Skin: Remove contaminated clothing immediately and wash skin with soap and water. In case of eczema or skin disorders: Seek medical attention and take along these instructions.
• Swallowed: Never give anything by mouth to a victim who is unconscious or is having convulsions. DO NOT INDUCE VOMITING. Rinse mouth thoroughly with water and give large amounts of water if person is conscious. Get medical attention.
• Breathing it in: If dust from the material is inhaled, remove the affected person immediately to fresh air. Call a POISON CENTER or doctor/physician if you feel unwell.

Fire

Use water fog, foam, dry chemical powder or carbon dioxide (CO2); avoid water jet. Self-contained breathing apparatus and full protective clothing must be worn in case of fire.

Spills

Avoid dust formation and inhalation; use a HEPA vacuum for dry spills or absorb/cover wet spills with dry earth, sand or other non-combustible material, then transfer to containers for disposal. Neutralize the spill area and flush with water afterward. Prevent entry into drains.

Summary taken from the SDS and checked by IDSDS. The full SDS is the official document.