Mar-flex

LiteFUSION Waterproofing SDS

Safety Data Sheet for Mar-flex LiteFUSION Waterproofing, revised 2015-05-05.

Open the full SDS (PDF)

Hazards

• May cause an allergic skin reaction
• May cause cancer.

Protective equipment

• Wear eye protection with side shields or goggles. Wear indirect-vent, impact and splash resistant goggles when working with liquids. If additional protection is needed for entire face, use in combinat
• Use of gloves approved to relevant standards made from the following materials may provide suitable chemical protection: PVC, neoprene or nitrile rubber gloves. Contaminated gloves should be replaced.
• Use of an apron and boots of chemically impervious materials such as neoprene or nitrile rubber is recommended to avoid skin sensitization.
• If engineering controls do not maintain airborne concentrations to a level which is adequate to protect worker, a respiratory protection program that meets or is equivalent to OSHA 29 CFR 1910.134 and

First aid

• Eyes: Rinse eyes cautiously with lukewarm, gently flowing water for 15-20 minutes, holding the eyelids open. Remove contact lenses if present and easy to do. If eye irritation persists: get medical advice/attention.
• Skin: Take off contaminated clothing, shoes and leather goods. Wash with plenty of lukewarm, gently flowing water and mild soap for 15-20 minutes. If skin irritation occurs: get medical advice/attention. Wash contaminated clothing before re-use.
• Swallowed: Rinse mouth. Do NOT induce vomiting. Immediately call a POISON CENTER/doctor. If vomiting occurs naturally, lie on your side in the recovery position. Never give anything by mouth to an unconscious person.
• Breathing it in: Remove source of exposure or move person to fresh air and keep comfortable for breathing. Get medical advice/attention if you feel unwell or are concerned.

Fire

Use dry chemical, foam, or carbon dioxide; sand or earth for small fires only. Do not use direct water stream. Wear protective pressure self-contained breathing apparatus (SCBA) and full turnout gear. Container may burst if heated.

Spills

Isolate hazard area and keep unnecessary people away. Do not touch or walk through spilled material. Contain and collect spilled materials with non-combustible, absorbent material and place in a container for disposal according to local regulations. Prevent entry into sewers and waterways.

Summary taken from the SDS and checked by IDSDS. The full SDS is the official document.