Mar-flex

ArmorPrimer 1200 SDS

Safety Data Sheet for Mar-flex ArmorPrimer 1200, revised 2015-03-25.

Open the full SDS (PDF)

Hazards

• Causes mild skin irritation
• Causes eye irritation
• Suspected of causing cancer.

Protective equipment

• Wear eye protection with side shields or goggles. Wear indirect-vent, impact and splash resistant goggles when working with liquids.
• If additional protection is needed for entire face, use in combination with a face shield.
• Use of gloves approved to relevant standards made from the following materials may provide suitable chemical protection: PVC, neoprene or nitrile rubber gloves.
• Use of an apron and boots of chemically impervious materials such as neoprene or nitrile rubber is recommended to avoid skin sensitization.
• If engineering controls do not maintain airborne concentrations to a level which is adequate to protect worker, a respiratory protection program that meets or is equivalent to OSHA 29 CFR 1910.134 and

First aid

• Eyes: Rinse eyes cautiously with lukewarm, gently flowing water for several minutes, while holding the eyelids open. Remove contact lenses, if present and easy to do. Continue rinsing for 15-20 minutes. If eye irritation persists: Get medical advice/attention.
• Skin: Take off contaminated clothing, shoes and leather goods. Wash with plenty of lukewarm, gently flowing water and mild soap for 15-20 minutes. If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before re-use.
• Swallowed: Rinse mouth. If you feel unwell/if concerned: Get medical advice/attention. Do NOT induce vomiting. If vomiting occurs naturally, lie on your side, in the recovery position.
• Breathing it in: Remove source of exposure or move person to fresh air and keep comfortable for breathing. Call a POISON CENTER/doctor if you feel unwell. If breathing is difficult, administer oxygen.

Fire

Use dry chemical, foam, or carbon dioxide; sand or earth for small fires only. Do not use direct water stream. Wear protective pressure self-contained breathing apparatus (SCBA) and full turnout gear.

Spills

Eliminate all ignition sources. Isolate the hazard area and keep unnecessary people away. Avoid breathing vapor and contact with skin, eyes or clothing. Contain and collect spilled material with non-combustible absorbent material and dispose of per local regulations.

Summary taken from the SDS and checked by IDSDS. The full SDS is the official document.