Andek

Clearcoat 44 SDS

Safety Data Sheet for Andek Clearcoat 44, revised 2026-03-22.

Open the full SDS (PDF)

Hazards

• Contains monomeric isophorone diisocyanate.
• Causes skin irritation.
• May cause allergic skin reaction
• May cause allergic respiratory reaction
• May cause eye irritation.
• May be harmful if aerosol or mist is inhaled.
• Closed containers may explode under extreme heat or when contaminated with water.
• Use cold water spray to cool fire-exposed containers to minimize the risk of rupture. Toxic gases / fumes are given off during burning or thermal decomposition.
• Do Not seal containers that have been contaminated with water.
• Flammable liquid and vapor.

Protective equipment

• Use Viton or 4H gloves.
• Long sleeved clothing and apron.
• In operations where the exposure limits can be exceeded, wear a NIOSH approved respirator selected by a technically qualified person.
• Safety glasses (with side shields)

First aid

• Eyes: In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical attention.
• Skin: For skin contact wipe away excess material with dry towel, then wash affected areas with plenty of water, and soap if available, for several minutes. Get medical attention if irritation occurs. Remove contaminated clothing and shoes.
• Swallowed: If swallowed, give 1-2 glasses of water, but Do Not induce vomiting. Do Not give anything by mouth to an unconscious or convulsing person. Get medical attention.
• Breathing it in: If inhaled, remove to fresh air. If not breathing give artificial respiration, preferably mouth-to-mouth. If breathing is difficult oxygen should be administered by qualified personnel. Call a physician or transport to a medical facility.

Fire

Extinguishing media: carbon dioxide, dry chemical, foam. If excessive fumes or smoke is encountered, wear self-contained breathing apparatus and full protective equipment. Sealed containers may build up pressure if exposed to heat; water can be used to cool the exterior of the containers.

Spills

Remove all sources of ignition and ventilate the area. Vapors are heavier than air and accumulate in low-lying areas. Soak up residue with an absorbent such as clay or sand and place in a non-leaking container for disposal. Clean area with a decontamination solution of 50% isopropyl alcohol, 45% water and 5% concentrated ammonia solution, left for at least an hour; allow for ventilation of containers as CO2 is generated.

Summary taken from the SDS and checked by IDSDS. The full SDS is the official document.