Andek

Buildkote SDS

Safety Data Sheet for Andek Buildkote, revised 2022-06-24.

Open the full SDS (PDF)

Hazards

• Combustible liquid.
• May be harmful if swallowed.
• May be harmful in contact with skin.
• Causes mild skin irritation.
• Causes eye irritation and may cause conjunctivitis.
• Harmful if inhaled.
• May cause respiratory irritation.
• May cause drowsiness or dizziness.

Protective equipment

• Chemical resistant goggles must be worn.
• Use impermeable gloves.
• A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 or applicable federal/provincial requirements must be followed whenever workplace conditions warrant respirator use.
• Wear protective gloves/protective clothing/eye protection/face protection.

First aid

• Eyes: Immediately flush eyes with plenty of water for at least 30 minutes, while holding eyelids apart. Do not allow contaminated water to contact the unaffected eye or face. Obtain medical attention immediately.
• Skin: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Thoroughly wash clothing, shoes and protective equipment before reuse or discard. Get medical attention if irritation develops or persists.
• Swallowed: Do not induce vomiting. If vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into the lungs. Get medical attention. If the heart or breathing has stopped, trained personnel should begin cardiopulmonary resuscitation or artificial respiration immediately.
• Breathing it in: Remove to fresh air. If breathing is difficult, give oxygen. If unconscious, evaluate the need for artificial respiration. Get immediate medical attention.

Fire

Use water spray or fog, foam, dry chemical or CO2. Wear self-contained positive-pressure breathing apparatus (MSHA/NIOSH approved or equivalent) and full protective gear. Containers can build up pressure if exposed to heat; cool with water spray. Vapors can travel to an ignition source and flash back.

Spills

Remove sources of ignition and ventilate area. Absorb spill with inert material, then place in a chemical waste container. Flush contaminated area with water and collect for disposal. Clean up spills immediately. Do not contaminate lakes, streams, ponds, groundwater or soil.

Summary taken from the SDS and checked by IDSDS. The full SDS is the official document.